This one was designed and built for a specific sub, she has not especially large but very saggy tits and the idea of this was to squish them in two different ways.
First the clamp section holds them tight making them bulge a bit then the clear plate is slowly screwed down to press them flat.
Unfortunately she is a bit shy so I don't have pics of this one in use, I have included some photos of the device though for those interested in constructing one.
Keen eyed observers will note I use Sketchup to design my toys, I find it save a lot of time and can often be used to solve practical issues prior to cutting any materials.
I used 16mm plywood for the main section and used a hole saw to cut the two main holes before slicing it in two.
There is a single central threaded rod to tighten the clamp then 4 threaded rods to hold and adjust the clear plate.
The plate is 5mm polycarbonate which is easy to cut and drill.
If anyone needs more details just contact me.
First the clamp section holds them tight making them bulge a bit then the clear plate is slowly screwed down to press them flat.
Unfortunately she is a bit shy so I don't have pics of this one in use, I have included some photos of the device though for those interested in constructing one.
Keen eyed observers will note I use Sketchup to design my toys, I find it save a lot of time and can often be used to solve practical issues prior to cutting any materials.
I used 16mm plywood for the main section and used a hole saw to cut the two main holes before slicing it in two.
There is a single central threaded rod to tighten the clamp then 4 threaded rods to hold and adjust the clear plate.
The plate is 5mm polycarbonate which is easy to cut and drill.
If anyone needs more details just contact me.